Even on a clear evening, the patio turns uninviting the second the sun drops. You’ve put together a clean, light-luxury outdoor room, and the kind of bulky heater that screams “utility” just doesn’t fit. We built our new infrared patio heater to close that gap—solid warmth that doesn’t steal the show.
What matters under the hood
We run a carbon fiber infrared element inside a slim, tempered-glass and aluminum body. Radiant heat comes on within seconds, putting out 1,500W across about 12 square metres. The 2.5-metre cord gives you real placement options, and the built-in thermostat keeps output steady instead of hunting up and down. For safety, there’s an overheat sensor and a tip-over switch that cuts power immediately. The unit is IP34 rated, so it’s protected against splashing water from any direction.
Why this approach works outside
This is the patio heater that blends into a modern, light-luxury setup. Clean lines and neutral finishes let it sit quietly on the deck or under a pergola, while the infrared warmth hits people directly—not the air. That means you feel cosy faster, and you lose less heat to wind. The upshot is longer, easier evenings outside, without the harsh glare or noise that kills the mood.
A few practical notes
Because infrared heats objects and people directly, comfort hits quickly, but the surrounding air stays cooler. For best results, position the unit so it has a clear “line of sight” to the seating area, and keep it at least 1 metre from combustible materials. It runs on standard household power—no special wiring—but it should be plugged into a grounded outlet on a circuit that can carry the full load. You’ll see a warm glow from the element while it’s on; that’s normal operation, not a defect.